Site map    Tel:+86-21-37709251    Contact Us Chinese
4 E1 TDM over IP | 4E1 over Ethernet Multiplexer
The 4E1 over ethernet multiplexer can support E1 or T1. The uplink have two 10/100M ethernet port. The 4E1 over IP device can managed by WEB management,easily used by customer.

  Request price     Contact us


As a cost effective solution for the traditional telecom services migrate to the IP packet networking technology(
time division multiplexing), BD-4E1-IP adopts the innovative TDM over IP technology, it transports the legacy E1/T1 data through the existing Ethernet or IP network.

BD-4E1-IP is the new generation of the TDM over IP equipment with IP circuit emulation that supports transportation of four E1/T1 and two local Ethernet ports over Ethernet or IP network. The uplink ports and user data ports are IEEE 802.3 compliant, 10/100BaseT auto-sensed Ethernet port.
The state-of-the-art design provides the highest availability with the accurate timing signal and data bit stream reconstruction. Predefined system parameter profiles that according to different application requirement; ultimately simplify the installation process and saving the maintenance cost.
Telecom and Enterprise users can save a lot of access and equipment costs and generates new revenue by offering different types of service over existing Ethernet networks. It is also suitable for connecting to the wireless equipment to achieve fast deployment of E1/T1 services. One particular application is to build E1/T1 links with low cost Wireless LAN bridges,replacing much more costly microwave radios. Operators can use BD-4E1-IP to provide legacy TDM services over wired or wireless packet network.

1. User-friendly Web server supported for easy setup and maintenance
2. Point to point and point to multipoint supported
3. Four E1/T1 Ports supported, E1 or T1 easy selected by Web Manager
4. Uplink ports 1+1 backup supported
5. Stable E1/T1 clock recovery, low jitter and wander
6. Low processing delay for E1/T1 channels, high bandwidth usage efficiency
7. Resist to packet loss, with PCM frame synchronization protection
8. User definable encapsulation packet size for different application
9. Enough jitter buffer to resist packet delay variation (PDV)
10. Local Ethernet port throughput limiting, assuring E1/T1 QoS
11. Local and remote E1/T1 LOS and AIS and packet loss indication for trouble-shooting and maintenance.                      

12. Support IETF RFC4553 SAToP protocol, Ethernet encapsulation support IP/UDP

13.  E1 clock supports 3 mode: local clock, adaptive and loopback

14.   Ethernet built-in layer 2 switch, support VLAN(port based, 802.1Q based and QinQ based), QoS(port based8021.1P basedMAC based and TOS based).

15.  Ethernet support IEEE 802.3x, RSTP (802.1w), LLDP, CDP, Ethernet ring protection, OAM and MAC address automatic learning

16.  Support POE (maximum power: 60W) (optional);


Technical Specifications

2 Uplink (1+1), 4 E1s/T1s, 2 User Data Port
Comply with IEEE 802.3
E1/T1 Port
4 E1 or 4 T1 Ports Supported
Comply with G.703
Impedance: E1-120Ω/T1-100Ω or 75Ω
User Data Port
2 User Data Ports Supported
Comply with IEEE 802.3
10/100Mbps auto-sensed
Full/Half Duplex auto-sensed
Web Manager Supported
-48V DC or 220V (110V) AC or dual power supply
Working Environment
0~ 50°C
Relative Humidity
≤90% (non-condensing)
W x H x D (mm):
440 x 44 x 230

Typical Application
   Application1: Point to Point Application,two units 4E1 TDM over IP work with voice device (PBX,PCM) and ethernet device (switch or router),realizing voice and ethernet data over ethernet network.

Application2: Point to multipoint Application,E1/4E1/8E1 TDM over IP work with 16E1 TDM over IP.

4e1 tdm over ip,ethernet over 4E1 tdm application

Application story:

Related Techinical solution:

How to make voie over ethernet transmission? How to extend phone lines?


Question1: Can the 4E1 of Baudcom's TDM over IP device can be used as four seperate E1 to transmit different business? For example, a E1 for Ethernet data transmission, one E1 for voice transmission and other for video image transmission.
Answer: Yes, Baudcom's 4E1 TDM over IP can transmit different business for every E1. The data in every E1 will be transparently transmitted.

Question2: Can Baudcom provide 1*RJ45 to 2*BNC male cable 50cm
Answer: Yes, Baudcom can provide the cable, but need to pay attention to line sequence.

Ordering information

Related Products

2E1 Over Ethernet TDM over IP Multiplexer

The 2E1 over ethernet multiplexer transportate T1/E1 over 10/100M ethernet transmission.

4E1 Fiber Multiplexer

4E1 over Fiber Multiplexer,E1 over fiber modem